Hi, I am new, so forgive me if this is a worn out question. I am using Eraser build 6.2.0 to erase some Seagate Barracuda 40 to 60 GB hard drives using the single pseudorandom pass. I can watch the progression with the green line. Eraser seems to complete the drive, but I get no completion message, so I cannot be certain the process was complete. It's like that task just drops off the list without any record of the task having been performed. I am not getting any error messages. I was getting some error messages until I changed the jumper on the hard drives to Cable Select which seems to have fixed that issue.
Thanks for any input,
Jennifer
Thanks for any input,
Jennifer