Default Task Type

F

FarmerJo

New Member
Currently the default task type is set to Run immediately. If it is changed to Run on restart, after the restart has completed it reverts back to Run immediately again. I looked for a configuration file so see if any of the defaults could be changed but could not find one. Checked the registry but found nothing obvious.

Does Eraser use a configuration file (or the registry) for its defaults?

Is it possible to set the task type to Run on restart and to keep this value after restart?

Regards FarmerJo
 
Not yet. Perhaps you'd like to open a Trac ticket.
 
You must log in or register to reply here.
Back
Top